Bond arms grizzly
The compact, yet rough-looking, Grizzly is a new type of Bond Arm gun. It’s built with a 3″ barrel chambered for 45LC/.410. Works best with smoothed lined holsters.
- Stainless steel double-barrel and frame
- Compatible with all standard Bond Arms barrels
- Patented rebounding hammer
- Retracting firing pins
- Cross-bolt safety
- Spring-loaded, cammed locking lever
- Holster Included
Not Available in California or Massachusetts.
How did we get the price down so low?
Bond Arms has been well known for having a premium fit and finish to every gun we make. To get to that level of aesthetic quality it takes a lot of time. We have taken that process and trimmed it down to create a gun that still has the robust qualities of our pre-existing models without all of the frills.
People have asked, are you using die cast or pot metals? The answer is NO!! They are all the same grade of stainless steel like our current production models.
To give you an idea of our current process for manufacturing our current guns, we literally sand every part, then we spend a tremendous amount of time Polishing and hand finishing all these same parts to the Quality Finish that Bond Arms has always been known for.
Quality Control (QC) on our current guns nearly borders on excessive. Once the guns are shot and all functions work as they should, our QC guys then go to extreme measures to find every cosmetic flaw, scratch, ding, or pit or anything else that didn’t pass our inspection. This means the guns are sent back to be fixed, which in most cases, involve totally disassembling the gun to re-polish or fix any flaw that they may find. On occasion the same gun may go through that same process 3 to 4 times until it passes QC.
Bond arms grizzly
With the Grizzly and Rough series, we do minimal clean up and deburr to make sure there are no sharp edges and then we bead blast the finish. With this gun, part of the COOL FACTOR is that you can actually see the parting lines in the metal frame and trigger guard. As a final touch we left in some of the swirly tool marks on the barrel just to give it that more ROUGH & TUMBLE Look. Also, since we are not sanding and polishing the frame, you may see tiny casting imperfections and rough areas that would never be acceptable for our current line of products.
This may not sound like much, but in comparison we can build 4 to 5 Grizzly’s in the same time as it takes to build ONE Texas Defender. That Is a Huge Amount of Savings on LABOR that allows us to pass those SAVINGS down to the consumer’s level.
After this past NRA show we saw that most of the higher volume sales of handguns were in the $300 to $350 and below range. When we came back from the show we set down and went part by part on our gun and by still using the same quality of parts we came up with ways to reduce cost on every part, but still build a TANK Of a Gun….